Versameling: Basis/Vaas Bottel

Broke your vase and need to re-use the thread/ring as your new vase comes without one? Or did your thread come loose? No worries at all, the fix is much easier than you think. 
Loose threads/ring can occasionally happen with any of the modern Hookahs as the glue might not have been applied efficiently (or the glue became weak after years of use or storage). There are many reasons and this affects any brand. 
It is not a big deal though and very easy to fix. 

 

How to fix your thread:

Step 1: You need to clean all the residue off the metal and glass (for example with steel wool or anything that gets it off completely). 
Step 2: Prime the glass and metal with some sandpaper. Make sure glass and thread/ring is clean and dry now.
Step 3: Put the epoxy 2-component glue (DO NOT BUY ANYTHING BUT CLEAR DRY & QUICK DRY & WATERPROOF) on the metal, covering all contact areas in a thin layer. Then do the same on the glass. Next press it on and check with iPhone app or similar that it sits level & center.

Step 3: The glue will change colour and get brittle, with patience and tools you can easily get off every last bit of glass. IF necessary repeat step 2

How to choose the correct base:
Step 1: Once you have taken the broken base off and you have the steel ring, take a ruler and measure the bottom of the ring(that fits into the base). Measure the inner part of the ring and NOT the outer side. 

 
Step 2: If the measurement reads for example 5.5cm(55mm), You can select a base that is 5.5cm. Each base on our page if you click on the product the images will open and you can see the measurements. 
Step 3: Make sure you also measure the downward stem that fits into the base. If its 25cm long then you can select a base that is 28cm heigh. 
Step 4: If you are still unsure please contact us on WhatsApp and we will gladly assist. 060 364 3130

Please bare in mind that if we have bases that have the ring already, there are two types of rings. There is a CLICK IN and SCREW IN. Please select the base that will suite the fitting you currently have. If your base is a PLUG IN then its easy to select a base. Normally its the G650 or the 3D design base.